收藏本站 English
  • 首页
  • 设施概况
    1. 设施简介
    2. 装置介绍
    3. 组织架构
    4. 设施建设队伍
  • 设施建设
    1. 建设进展
    2. 研究成果
    3. 学术交流
  • 人才招聘
    1. 人才招聘告示
  • 科普宣传
    1. 科普视频
    2. 科普文章
  • OA办公
  • 首页
  • 设施概况
    • 返回
    • 设施简介
    • 装置介绍
    • 组织架构
    • 设施建设队伍
  • 设施建设
    • 返回
    • 建设进展
    • 研究成果
    • 学术交流
  • 人才招聘
    • 返回
    • 人才招聘告示
  • 科普宣传
    • 返回
    • 科普视频
    • 科普文章
  • OA办公

研究成果

    研究成果

    当前位置: 首页  -  研究成果  -  正文

    Noise investigation of an electrostatic accelerometer by a high-voltage levitation method combined with a translation tilt compensation pendulum bench

    Shuang Hu, 1 Shixun Pei, 1 Ming Hu, 2 Yanzheng Bai, 1 Hongyin Li, 1 Li Liu, 1 Boxiang Yang, 1

    Shuchao Wu, 1,a) and Zebing Zhou 1,b)

     

    A high precision electrostatic accelerometer has widely been employed to measure gravity gradients and detect gravitational waves in space. The high-voltage levitation method is one of the solutions for testing electrostatic accelerometers on the ground, which aims at simultane-ouslydetectingallsix-degree-of freedom movements of the electrostatic accelerometers engineering and flight prototypes. However, the noise performance in the high-voltage levitation test is mainly limited by seismic noise. The combined test of the accelerometer and vibration isolation platform is adopted to improve the detection precision of the high-voltage levitation method. In this paper, a high precision electrostatic accelerometer prototype is developed after designed appropriate mechanical parameters with a test mass weighing 300 g and with an estimated resolution of 2×10−12m/s2/Hz1/2 from 0.01 to 0.4 Hz. Such a prototype is tested by the high-voltage levitation method, its measurement noise on the ground is mainly limited by the seismic noise, which is about 5×10−7m/s2/Hz1/2 around 0.2 Hz and about 4×10−8m/s2/Hz1/2 around 0.1 Hz. A vibration isolation pendulum bench based on the translation–tilt compensation principle is adopted for accelerometer prototype combined tests to suppress the seismic noise, which has a large bench area and the ability to adjust the tilt angle precisely. The measured accelerometer noise of the combined test with the translation–tilt compensation pendulum has reached 3×10−9m/s2/Hz1/2 around 0.2Hz, and it is about two orders of magnitude lower than the measurement noise on the ground. The combined test method provides technical guidance for further improving the noise level of ground test in the future.

    期刊名:Review of Scientific Instruments

    期/卷: Vol. 92, Issue 6

    页码:064502

    发表时间:2021年6月

    DOI: 10.1063/5.0042938

    上一篇: A low frequency horizontal active vibration

    下一篇: Data Collection in MI-Assisted Wireless

    华中科技大学引力中心 华中科技大学物理学院 华中科技大学

    地址:中国·湖北省·武汉市珞喻路1037号 

    邮编:430074 | 电话:(+86)027-87542391

    Copyright 2021 ◎ 华中科技大学精密重力测量国家重大科技基础设施